Avocent DSR1020 - Manual (Page 36)

28 DSR Switch Installer/User Guide
3. Determine the order within the list to add the target device. If there are no target devices in the
Scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a target device to the end of the list, place your cursor in the last target device entry and
press the
Down Arrow key.
-or-
To add a target device within an existing list, place your cursor in the line below where you want
to insert a new target device and press
Insert .
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a.
Press Alt+Down Arrow to move the cursor down through the list of target devices.
b. Press Alt+Up Arrow to move the cursor up through the list of target devices.
c. Press Alt+Home to move the cursor to the first target device in the list.
d. Press Alt+End to move the cursor to the last target device in the list.
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press Down Arrow and repeat steps 2-5 for each of the
remaining target devices to be included in the scan pattern.
7. Click OK.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press
Delete .
-or-
Press
Shift+Delete to remove the selected target device and all entries below it.
3. Click OK.
To start the Scan mode:
1. If the OSCAR interface is not open, press Print Screen. The Main dialog box will appear.
2. Click Commands. The Commands dialog box appears.