Directed Electronics Ready Remote - Manual (Page 26)

22 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
Place the wire with the spade connector onto the pin switch and
run the wire into the vehicle’s passenger compartment through a
factory rubber grommet. Using a sharp, pointed object poke a
hole into the grommet and attach the wire to the object with
electrical tape. Pull the wire through the grommet taking extra
care to keep the wire away from any moving parts or anything
that will generate extreme heat. Once the wire is run into the
vehicle and secured from any moving parts, solder the wire to
the GRAY (H1/4) wire of the main harness and wrap the
connection with electrical tape.
The bypass toggle switch is designed to bypass the remote start
in an emergency or to disable the remote start functions
temporarily (i.e., for service on the vehicle or when parking in an
enclosed area). This switch is to be mounted in an easily acces-
sible location in the passenger compartment.
Connect the toggle switch as shown below. The Gray (H1/4)
wire to the hood pin switch, and the Black wire from the switch
to ground. The toggle switch must be in the Off position for
normal operation.
warning! This wire MUST be connected. Do
not use the vehicle until you confirm the oper-
ation of the hood pin shutdown. Improper
operation could result injury or death.