ABUS Technologies USI-C Universal Smart Isolator Hand-Held Configurator - Manual

USI-C Universal Smart Isolator
Hand-Held Configurator
Introduction
OPERATION MANUAL
ABUSTEK
USI-C Series Configurator is a handheld configurator for Smart
Programmable Isolator. The new handhelds come with a 2.6
inch (3.6 cm) display having 2 lines with 128 by 128 pixel
resolution. A SET Key function allows the user to scroll a list of
all editable parameters regardless of their position in the
configuration menu structure.
Thank You
Panel
Configuration Process
Communication Process
8 8 8 8
8 8 8 8
SET A/M
ON OFF
AUTO POWER OFF
SPI-C
5
1
2
3
4
1. Measured value (PV) display- It displays PV or various
parameter symbols.
2. Set value (SV) display- It displays SV or various
parameter set values.
3. Indication Lamps
○ => SP1 alarm
○ => SP2 alarm
○ => SP3 alarm
○ => Communication lamp
4. Set Key- It is used for parameter calling up and set value
registration.
Up Key- It increase numerals or build communication.
Down Key- It decreases the numerals.
Shift Key- It shifts the digits when settings are changed.
On Key- It is used to Power On the instrument.
Off Key- It is used to Power Off the instrument.
Function Key- It is used to return the previous parameter.
6. USB Data Link cable.
S e l
5 5 5
S e l
1 0 1
I n
0 0
1. Turn on the power supply of transmitter in right awy.
2. Connect handheld configurator with transmitter by USB
link cable.
3. Press the UP Key of handheld configurator, in order to
start Communication.
4. Once communication is initialized, Communication Lamp
as well as the Power Lamp in the Transmitter will
Flash.
S e l
5 5 5
1. Initialization Mode
After communication is OK, Press SET key
followed by A/M key to enter into Initialization Mode.
2. Initial Setting Menu
The “SEL” is displayed when the handheld
configurator goes into initialization mode.
Set “SEL” to 101
Press SET key
INITIALIZATION MODE
INITIAL SETTING MENU