Applied Motion 1035D - Manual (Page 5)

motor
supply
12-35 VDC
+
–
Connecting the Motor
Warning: When connecting the motor to the driver, be sure that the
motor power supply is off. Secure any unused motor leads so that they
can't short out to anything. Never disconnect the motor while the drive
is powered up. Never connect motor leads to ground or to a power
supply!
You must now decide how to connect your
motor to the drive.
Four lead motors can only be connected
one way. Please follow the sketch at the
right.
Six lead motors can be connected in
series or center tap. In series mode, motors
produce more torque at low speeds, but
cannot run as fast as in the center tap
configuration. In series operation, the motor
should be operated at 30% less than the rated current to prevent overheating.
Winding diagrams for both connection methods are shown on the next page
Connecting the Power Supply
A+
A-
B+ B-
4
lead
motor
Red
Blue
Yellow White
4 Leads
-12- -5-
2A slow blow
fuse
If you need information about choosing a power supply, please read Choosing a
Power Supply located in the back of this manual.
If your power supply does not have a fuse on the output or some kind of short
circuit current limiting feature you need to put a 2 amp slow blow fuse between the
drive and power supply. Install the fuse on the positive power supply lead.
Connect the motor power supply positive terminal to the driver terminal marked
"+". Connect power supply return to the drive terminal marked "-". Use no
smaller than 20 gauge wire. Be careful not to reverse the wires. Reverse
connection will destroy your driver, void your warranty and generally wreck your
day.
The amplifiers and voltage regulator in the 1035D have been specially designed for
maximum efficiency. Still, they generate some heat, which must leave the 1035D
through the slots in the case.
Never use your drive where there is no air flow.
Always mount the drive vertically.
Never block the ventiliation slots.
Never put the drive where it can get wet or where metal particles can
get on it.
Mounting the Drive
The 1035D is designed for DIN rail mounting. First, secure a piece of 35mm
(EN50022) DIN rail to a rigid surface. Normally, that would be the wall of a wiring
cabinet. Then hang the 1035D on the DIN rail and press the blue plastic tab to lock
the drive to the rail.
Step 1
Hang Drive on DIN Rail
Step 2
Press Blue
Latching Tab