Applied Motion STAC6-Si - Manual

STAC6
STAC6-S/Q/Si Quick Setup Guide
Requirements
▪ A compatible stepper motor.
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A personal computer running Microsoft Windows 95, 98, NT, Me, 2000, XP, Vista or 7 (32- or 64-bit).
▪ For STAC6-S and STAC6-Q, ST Configurator™ software, available at: http://www.applied-motion.com/products/software
▪ For STAC6-Si, Si Programmer™ software, available at: http://www.applied-motion.com/products/software
▪ An Applied Motion programming cable (included).
▪ For more detailed information, please download and read the STAC6 Hardware
Manual, available at http://www.applied-motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 1
Wire the drive to the AC power source.
(apply power only after step 4 is completed
and the programming cable is connected)
STAC6x drives accept 94-135VAC
STAC6x-220 drives accept 94-265VAC
If using an external fuse, we recommend the
following fast-acting fuses:
STAC6x : 6 amp
STAC6x-220 : 5 amp
920-0060 Rev A
Earth Ground
Neutral
Line (Hot)
GREEN
SHIELD
RED
BLACK
WHITE
SHLD
B-
B+
A-
A+
BLUE
ORANGE
BROWN
YELLOW
A+
A–
B+ B–
8
lead
motor
Series Connected
8 Leads Parallel Connected
A+
A–
B+ B–
8
lead
motor
White
Orange
Brown
Green
Red
Yellow Blue
Black
Orange
Red
Brown
Yellow
Blue Black
White
Green
SHLD
SHLD
A+
A–
B+ B–
8
lead
motor
Series Connected
8 Leads Parallel Connected
A+
A–
B+ B–
8
lead
motor
White
Orange
Brown
Green
Red
Yellow Blue
Black
Orange
Red
Brown
Yellow
Blue Black
White
Green
SHLD SHLD
GREEN
SHIELD
RED
BLACK
WHITE
SHLD
B-
B+
A-
A+
BLUE
ORANGE
BROWN
YELLOW
Wire the motor. See the STAC6 Hardware Manual for
further details.
Series connection
Use with all STAC6-220 drives and the following
motors:
▪ HT23-552, HT23-553, HT23-554
▪ HT34-495, HT34-496, HT34-497
Use with STAC6 (120) drives and the following motors:
▪ HT23-548, HT23-549, HT23-550
▪ HT34-488, HT34-489, HT34-490
Parallel connection
Do not use parallel connection with STAC6-220 drives.
Use with STAC6 (120) drives and the following motors:
▪ HT23-552, HT23-553, HT23-554
▪ HT34-495, HT34-496, HT34-497
Step 2