Applied Motion STM23IP-2EE - Manual

STM23 Ethernet Quick
Setup Guide
Requirements
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A 12-70V DC power supply.
▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit).
▪ ST Configurator™ software (available at www.applied-motion.com/products/software).
▪ A CAT5 network cable (not included).
▪ For more detailed information, please download and read the STM23 Hardware Manual, available at www.applied-motion.
com/support/manuals.
To begin, make sure you have the following equipment:
Step 2
a) Download and install the ST Configurator™ software.
b) If you intend to connect the drive directly to your PC, configure your computer to use IP address 10.10.10.11. (For
instructions on connecting your STM drive to a local area network (LAN), please consult the STM23 Hardware Manual)
c) On the STM23, select switch position 0, which will assign IP address 10.10.10.10. (See the STM23 Hardware Manual
for further details on selecting IP addresses for the drive and PC)
d) Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Configurator
Step 1
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note - the STM23 accepts DC voltages from 12-70V. If using an
external fuse, we recommend a 4 amp fast acting fuse.
(See the STM23 Hardware Manual for more information about
power supply and fuse selection.)
Connect I/O, if required by your application.
(See the STM23 Hardware Manual for more information about
wiring I/O to the STM23.)
920-0058A
GND
+VDC