Applied Motion STM23Q-2RE - Manual

STM23/24 Quick Setup Guide
Requirements
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 and 64 bit) and Windows 8.
▪ ST Configurator™ software (available at www.applied-motion.com/products/software).
▪ For RS-232 models: an Applied Motion programming cable (included)
▪ For RS-485 models: an RS-422 or RS-485 port or adapter for your PC (see reverse for recommended RS-485 adapter)
▪ For more detailed information, please download and read the STM23 Hardware Manual (or STM24 Hardware Manual),
available at www.applied-motion.com/support/manuals.
To begin, make sure you have the following equipment:
Step 1
a) Download and install the ST Configurator™ software.
b) Launch the software by clicking:
Start / Programs / Applied Motion Products / ST Configurator
c) Select the correct COM port using the drop down list
d) Connect the drive to your PC using the RS-232 programming cable
or RS-422/485 adaptor
Step 2
Wire the drive to the DC power source.
(do not apply power until all connections to the drive have been made)
Note, the STM23 and STM24 accept DC voltages from 12-70V.
If using an external fuse, we recommend the following:
STM23 : 3AG, 4 amp (Littlefuse 313004P)
STM24 : 3AG, 5 amp (Littlefuse 313005P)
See the product hardware manual for more information about
power supply and fuse selection.
+
-
STEP+
STEP-
DIR+
DIR-
EN+
EN-
OUT+
OUT-
+5V
AIN
GND
920-0020 E
I/O1+
I/O1-
I/O2+
I/O2-
I/O3+
I/O3-
I/O4+
I/O4-
+5V
AIN
GND
STM w/ Standard I/O STM w/ Flex I/O