Atlona AT80CHD 1 - Manual (Page 3)

2 www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
The Atlona HDMI with Component and Audio wall plates are the perfect solution to make your in wall Cable installation
look professional and seamless. These wall plates feature a 4 inch strain relief HDMI cable that prevents damage to ex-
pensive CL rated in wall HDMI cables, saving you countless time and money from re-installing damaged cables. Atlona’s
wall plates boast 24k gold connector ends ensuring that no signal is lost as it passes through. Theses wall plates also
feature a paintable cosmetic cover that hides screws and rough drywall edges. Atlona’s wall plates are so simple to install
that you will not need to hire a professional. Just plug in and enjoy!
Note:The wall plate terminals will accomodate only standard HDMI connectors (HDMI Type A) and standard YbPbr (RCA
type) Plus analog audio connectors.
A great product for custom applications. If you want to hide your wires in the walls, it would be really hard to not use a
wall plate. This wall plate features 24k gold plated HDMI and Component receptacles. This wall plate supports any HDMI
type connectors and RCA type for Component and Audio. Compatible with any single gang box. 5 inch wire on the rear
of the wall plate will allow you to easily connect cable running in the wall to the wall plate without bending it.
INTRODUCTION
APPLICATIONS
Max. Resolution 1080p
Wall Plate type Single Gang
HDMI Compatibility Ver. 1.3
Inputs 1 x HDMI, 1 x Component (3-RCA), 1 x Stereo Audio (2-RCA)
Outputs 1 x HDMI, 1 x Component (3-RCA), 1 x Stereo Audio (2-RCA)
Extension Cables 4-inch HDMI
SPECIFICATIONS
INSTALLATION
You can mount this HD video wall plate using a standard single electrical box.
1. Route the cables through the opening in the back of the electrical box
2. Rear HDMI connectors are attached to a short extension cables to prevent wallplate and HDMI cable damage
3. Connect RCA type component and analog audio connectors to the rear side of the wall plate
4. Remove the Face plate from the wall plate by pushing down on HDMI and RCA connectors with your thumbs and at
the same time pulling two opposite corners away. Under the face plate you will find two screws hidden there. Place the
wall plate against the opening of the electrical box, then thread the two supplied screws through the screw holes in the
wall plate and the electrical box, then tighten the screws and reattach the face plate.