Atlona AT VGA0505 - Manual (Page 11)

10 www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
How to operate
Method A: Assign ouput X to play input Y
1. Press first
then use or to select the output channel “X”.
2. Once you see the LED displays the desired output channel “X” then press and then use or to
select the input channel “Y”.
3. Once you reach the desire input & output channel setting, wait for 2 seconds and it’ll be done.
Method B: Assign input X to be displayed on output Y
1. Press
first then use or to select the input channel “X”.
2. Once you see the LED displays the desired input channel “X” then press and then use or to
select the output channel “Y”.
3. Once you reach the desire input & output channel setting, wait for 2 seconds and it’ll be done.
Method C: Use hot keys to assign input X to be displayed on all 5 outputs
1. Press
if you want to have input channel 1 to be shown on all 5 outputs.
2. Press you want to have input channel 1 to be shown on all 5 outputs.
3. Press you want to have input channel 1 to be shown on all 5 outputs.
4. Press you want to have input channel 1 to be shown on all 5 outputs.
5. Press you want to have input channel 1 to be shown on all 5 outputs.
Method D: Use hot keys to assign input X to be displayed on output X
1. Press
then you can get the same default channel mapping in software control, as you can see the
mapping table below.
Source Channel Display Channel
Input 1 Output 1
Input 2 Output 2
Input 3 Output 3
Input 4 Output 4
Input 5 Output 5