Atlona AT LINE PRO4 GEN2 - Manual (Page 8)

atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Command
Set Commands
The command codes are very sensitive, do not change capitalization, spacing, or lettering.
Command Feedback Description
S POWER 0 >POWER OFF Power on
S POWER 1 >POWER ON Power off
S SOURCE 0 >SOURCE CV Set the input to CV
S SOURCE 1 > SOURCE SV Set the input to SV
S SOURCE 2 > SOURCE COMP Set the input to COMP
S SOURCE 3 > SOURCE PC1 Set the input to PC1
S SOURCE 4 > SOURCE PC2 Set the input to PC2
S SOURCE 5 > SOURCE PC3 Set the input to PC3
S SOURCE 6 > SOURCE HDMI1 Set the input to HDMI1
S SOURCE 7 > SOURCE HDMI2 Set the input to HDMI2
S SOURCE 8 > SOURCE HDMI3 Set the input to HDMI3
S SOURCE 9 > SOURCE HDMI4 Set the input to HDMI4
S OUTPUT 0 > OUTPUT NATIVE Set the output EDID to native
S OUTPUT 1 > OUTPUT VGA Set the output EDID to VGA(640X480@60)
S OUTPUT 2 > OUTPUT SVGA Set the output EDID to SVGA(800X600@60)
S OUTPUT 3 > OUTPUT XGA Set the output EDID to XGA(1024X768@60)
S OUTPUT 4 > OUTPUT SXGA Set the output EDID to SXGA(1280X1024@60)
S OUTPUT 5 > OUTPUT UXGA Set the output EDID to UXGA(1600X1200@60)
S OUTPUT 6 > OUTPUT 480i Set the output EDID to 480i
S OUTPUT 7 > OUTPUT 480p Set the output EDID to 480p
S OUTPUT 8 > OUTPUT 720p Set the output EDID to 720p@60
S OUTPUT 9 > OUTPUT 1080i Set the output EDID to 1080i@60
S OUTPUT 10 > OUTPUT 1080p Set the output EDID to 1080p@60
S OUTPUT 11 > OUTPUT 576i Set the output EDID to 576i@60
S OUTPUT 12 > OUTPUT 576p Set the output EDID to 576p@60
S OUTPUT 13 > OUTPUT 720p Set the output EDID to 720p@50
S OUTPUT 14 > OUTPUT 1080i50 Set the output EDID to 1080i@50
S OUTPUT 15 > OUTPUT 1080p50 Set the output EDID to 1080p@50
S OUTPUT 16 > OUTPUT WXGA Set the output EDID to WXGA (1280x800@60)
S OUTPUT 17 > OUTPUT WSXGA Set the output EDID to WSXGA (1680x1050@60)
S OUTPUT 18 > OUTPUT WUXGA Set the output EDID to WUXGA (1920X1200@60)
Note: Each command or feedback is terminated with a carriage return.
Note: If the command fails or is incorrect the feedback should be “Command FAILED”
8