Atlona AT HD600 - Manual (Page 4)

3.1 Front Panel
1. Power switch and power LED indicator: Press the switch to power on the unit and the power LED will illuminate.
2. IR sensor.
3. Input source selection: Press the input button to switch to your desired input sources, the LED will illuminate to
indicate which input source is selected.
4. Audio delay: Press to delay audio sources for 150ms, the LED will illuminate when powered on.
3.2 Rear Panel
1. Power: Plug the 5V DC power supply into this unit and connect the adaptor to AC wall outlet.
2. CV/SV inputs: Connect each of the input ports to the CV/SV and R/L output ports of your source equipments such
as DVD player or set-top- box. The CV1/SV1/Audio1 and CV2/SV2/Audio2 are individual loops for source equip-
ments.
3. Component inputs: Connect each ofthe input component ports to the component and R/L output ports ofyour
source equipments such as DVD playerorset-top-box. The Componentl/Component Audiol and Component2/ Com-
ponent Audio2 are individual loops for source equipments.
4. HDMI inputs: Connect each of the input ports to the HDMI or DVI output ports of your source equipment such as
a DVD player or set-top-box.
5. PC input: Connect PC/audio input port to the PC/audio output port ofyour source equipment such as a Note¬book
or PC.
6. RS232: 9-pin D-Sub connector for connecting to your PC or other control consoles from remote control.
7. HDMI output: Connect the output port to the HDMI display.
OPERATION CONTROLS AND FUNCTIONS
1 2 3 4
1 2 3 4 5 6 7
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
3