Atlona AT HD V1616M V2 - Manual (Page 5)

Toll free: 1-877-536-3976
Local: 1-408-962-0515 5 atlona.com
Back
1. Video Inputs. Sources such as DVD players and computers should be connected here.
2. Video Outputs. Video displays should be connected here.
3. Power Regulator. Switch between 110V (US standard) and 220V (EU base standard).
4. RS-232 connector. Connect included RS-232 cable here if you wish to control your switcher by PC
or 3rd party controller
5. TCP/IP connector. Connect to your switcher through a network by connecting an Ethernet cable
here.
6. Primary and Secondary Power Supply. Connect included power cables here.
Panel Control
AV : Used to select input to output. Example: Input 3 to output 5 - Press 3 then AV then 5
(displays as 3AV5 on the LCD display)
“,” : Select multiple outputs with this. Example: Input 1 to output 3-5. Press 1 then AV then 3,4,5
(displays as 1AV345)
ALL : Press to connect all outputs for an input. Example: Input 2 to all outputs. Press 2ALL
Through : Sends inputs to corresponding outputs. Example: Input 4 to output 4. Press 4Through
Memory: Save the current settings for the switcher to create a reset between 0-9. Press Memory3
to save as preset 3
Recall: Uses saved presets that you’ve created. Press Recall3 to pull up what you saved with
Memory3
Undo: Goes back one step, if you’ve changed the wrong item and want it to go back to what it
was press undo
Enter: Used to end each selection. Example: 3AV5, press enter after to confirm your choice
<--: Used for EDID selection or as a backspace. Hold for 10 seconds for EDID commands
1 2 3 4 5 6