Atlona AT COMP 44M - Manual (Page 6)

Before making any connections to the AT-COMP-44M Observe the following:
Mains voltage supply must matches the label on the supplied plug-Pack (+/- 10%)
Power switch is OFF
All system grounds (earth) must be connected to a common point.
Avoid powering equipment within a system from multiple power sources that may be separated by large
distances
Connect all audio video sources and destination equipment
Power up all sources
For each destination output select the appropriate input source by usingthe front panel input 1-4 select
buttons, the supplied IR remote control or through the RS 232 serial communications port.
Upon power up, the switcher will return to its last used setting before powered down.
Series Code: 24 DB
1. Power On or Off
Controller with a separate power to turn ON and OFF
2.Outputs1- 4: Output to desired displays
Output -1: TV-1 Component Video (YPBPR) HDTV Display
Output -2: TV-2 Component Video (YPBPR) HDTV Display
Output -3: TV-3 Component Video (YPBPR) HDTV Display
Output -4: TV-4 Component Video (YPBPR) HDTV Display
3.Inputs 1-4: Input Video Source Selections
Input -1: AV-1 Component Video (YPBPR) Signal source device
Input -2: AV-2 Component Video (YPBPR) Signal source device
Input -3: AV-3 Component Video (YPBPR) Signal source device
Input -4: AV-4 Component Video (YPBPR) Signal source device
4
REMOTE CONTROL