Atlona AT HD610 V2 - Manual (Page 4)

4
1. HDMI OUT - Connect to an HDMI display
2. Status LED - Illuminates when passing signal to a display. Blinks when learning EDID
3. Mode dial - Switches between switcher modes and EDIDs
0: Selects audio from the Stereo audio in
1: Selects audio from the S/PDIF audio in
6: Sets to default EDID
*based off highest common resolution between source and 1080p, 720p, and 480p
7: EDID learn mode
4. POWER LED - Illuminates when receiving power
5. DC 5V POWER - Plug the included power supply here
1. S/PDFI IN - 2Ch digital S/PDIF audio input
2. STEREO IN - 2Ch analog audio input
3. DVI-D IN - Connect a DVI source
2
6
0 4
7 5
3 1
2
6
0 4
7 5
3 1
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Panel Description
Front Panel
Back Panel
1
1
2
2
3
3
4 5
EDID Learn
1. Turn on the HD610
2. Connect display to HDMI out
3. Turn the dial clockwise from 0 to 7
Status LED will illuminate while learning. When LED goes dark, the status LED will go dark.
4. Turn the dial clockwise from 7 to 0 (or 1 if using S/PDIF audio)
Do not go past 6 or the learned EDID will erase and reset to default