Installation, Ab c – Audio Solutions FM2260 User Manual
Page 9
Advertising
9
SteP 6
NOTE: Angle adjustment should be done by at least two people.
•
(A) While another person is holding the television assembly, loosen the two handles on either side
of the mounting plate and tilt the television up to 5 degrees back or 15 degrees forward. Tighten the
handles when the desired angle is achieved. See Figure 9.
•
(B) With assistance, adjust the main bracket to move the television out from the wall and angle up to
90 degrees either left or right. Pay attention to wiring to ensure wires are not damaged during angle
adjustment. See Figure 9.
•
(C) Extend the bracket arm fully and then use the attached wire clips to secure wires to the arm. See
Figure 9.
A
B
C
Figure 9 - Adjust Angle
INStAllAtION
Advertising