AXING SKP 2-10 - Manual (Page 10)

Operation Instructions SKP 2-10
Chapter 3: Programming
10 © AXING AG • Swizzerland • Reserving change in design and type 16.02.12
3.2 Programming input channels via OSD
After programming the output channels of the SKP 2-10, the starting window will be displayed. A
measuring device or a TV receiver must be connected to the output of the SKP 2-10 or the active output
combiner and must be aligned with the respective output channel..
Serial number and software version of the respective twin module is displayed.
The set output channel is shown on the Display.
As some channels are pre-programmed in the modules, a pre-set channel is opened. Information about
SAT position, frequency, symbol rate, FEC and VPID is shown. The image of the channel is only visible,
if the head end is configured for this satellite.
If no pre-programming exists, the starting window (see Fig. 7) is displayed permanently..
3.3 On-Screen Programming
The module to be programmed can be selected by means of the programming selection switch.
The measuring device must be aligned to the respective output channel. If a monitor is used, it must be
connected to the respective duct via the AV-Cinch outputs of the module. (Cinch/RCA cables or
cinch/RCA to scart cables)
After pressing the menu key, the main menu opens.
The desired menu item is selected by means of the CH ▲/ CH ▼key.
Fig. 7: Start window
Fig. 8: Preprogramming
Fig. 9: Main menu