Brennenstuhl Solar LED Wall Lamp SOL 04 plus IP44 with PIR sensor 2xLED 0,5W 85lm Colour Grey white - Manual (Page 7)

7
Solar LED-Wall Light SOL 04 PLUS
good detection poor detection
• Mount the lamp such that the solar module receives the maximum possible DIRECT
SUNLIGHT during the day.
INSTALLATION STEPS
1. Remove the light’s mounting plate by opening the locking mechanism using the en-
closed key and turning it toward „OPEN“.
2. Drill two holes in the wall on which you wish to install the lamp and mount the mounting
plate with the screws (see Fig. 2).
3. Mount the lamp on the mounting plate and secure it by turning the key to „LOCK“. Re-
move the key and keep it for future use.
OPERATION
1. The rechargeable batteries inside are charged by the solar module. The longer the solar
module is exposed to direct sunlight during theday, the longer the light can remain on.
Before starting to use the light, the batteries should be charged in sunlight for at least 3
to 4 days (slider switch set to OFF). Alternately, the batteries can be charged with a
standard battery charger.
2. After the batteries are charged, the lamp can be used. The following operational modes
can be set on the slider switch on the back of the housing.
1B
2
015209 Solar-Wandleuchte SOL 04_015209 Solar-Wandleuchte SOL 04 BA 11.12.12 09:20 Seite 7