Brennenstuhl Solar LED Pavement Light SOL FL 13007 with PIR sensor and twilight sensor 13xLED 91lm Colour Alu/Silver - Manual (Page 6)

6
D
Operating Instructions SOL FL 13007 Solar Path Light
PLACEMENT OF THE SOLAR PATH LIGHT
1. For best results the solar path light should be placed in a location where it receives maximum
sunlight and is not covered or in the shade
2. Make sure the light is not subject to interference from other light sources. Otherwise, the lamp
will not light up at dusk.
3. For optimal operation the solar path light must be charged in sunny weather for a period of at
least 2 – 3 days.
4. When looking for a suitable location, make sure the horizontal detection range of the motion
detector is approx. 90º within a range of approx. 5 metres.
90°
90°
5m
ASSEMBLY AND INSTALLATION OF THE SOLAR PATH LIGHT
Carefully remove the solar path light and all other parts from the carton.
1. Remove the socket
4 from the column and remove the ground spike 5 .
2. Find a suitable location for the light and make sure the motion detector points in the desired
direction.
3. Attach the ground spike to the underside of the lamp. Install the lamp by pushing the ground
spike into the soil.
By using the plastic socket 4 the light can also be mounted directly to a concrete or wooden
surface. Attach the lamp socket using the screws (included), then attach the lamppost.
ACTIVATION
1. Remove the lamp head
6 from the column and set the AUTO / OFF switch 9 to AUTO. When the
switch is in AUTO mode the light will operate continuously after dark.
2. The light features 1 standby LED. An additional 12 LEDs switch on if the motion detector is
triggered.
3. When the switch is in the OFF position the lamp does not light up, although the battery will
continue to charge during the day.
BA_SOL_FL_13007_DR_0327_Aenderung_140320.indd 6 20.03.14 10:00