Channel Master Titan 2 Preamplifiers (7777) - Manual (Page 6)

TITAN 2
™
4
INSTALLATION
1. Internal switch selection. If you
are using a single antenna for TV
signals only, there is no need to
adjust the internal switches in the
amplifier.
NOTE: If you are using the antenna
for FM radio signals as well as TV,
then select the “OUT” position on
the FM trap switch. See Fig 1.
2. Using the U CLAMP, mount the
grey outdoor amplifier to the mast
below the antenna. See Fig 2.
3. With a short length of coaxial cable (not included),
connect the antenna to the “INPUT” on the amplifier.
See Fig 2.
4. Connect the down lead coaxial cable (not included)
to the connection labeled “OUTPUT/POWER.” Cable
tie the cable to the mast to prevent stress on the
connector.
5. Run the down lead coaxial cable (not included) into
the home to a location where an AC power outlet is
available. Connect this coax to the connection labeled
“TO AMP” of the power inserter. See Fig 2.
IMPORTANT: There should NOT be any signal splitters
located in this coaxial cable line between the outdoor
amplifier and the indoor power supply. Splitters must be
located on the “TO TV” side of the power inserter. See
Fig 3.
6. Connect the coaxial cable (not included) that
distributes the signal to the TV to the “TO TV” port of
the power inserter and connect the power supply to
the “DC IN” port of the power inserter with the six foot
FM Switch
To change settings,
remove four screws
from the cover.
Out
In