COMMELL ADP-L2DXT User Manual
Page 10
Advertising
ADP-L2DXT User’s manual
9
To setup the LCD, you need the component below:
1.
A panel with LVDS interfaces.
2.
An inverter for panel’s backlight power.
3.
A LCD cable and an inverter cable.
4. A
motherboard
For the cables, please follow the pin assignment of the connector to make a cable,
because every panel has its own pin assignment, so we do not provide a standard
cable; please find a local cable manufacture to make cables.
LCD Installation Guide:
1. Preparing
the
motherboard (
LP-170),ADP-L2DXT, LCD panel and the backlight
inverter.
2. Please check the datasheet of the panel to see the voltage of the panel, and set the
jumper JVLCD(LP-170) to +5V or +3.3V.
Advertising