CP Electronics VITM4 - Manual

The Vitesse modular system is a cost effective method of providing power and control for lighting installations in indus-
trial, commercial and retail buildings. The system is designed for ease of installation: mains input is connected using the
spacious wiring compartment; control inputs and outputs are pluggable using industry standard connectors. The modular
approach allows for between 4 and 16 luminaires to be connected. The VITM4 is for use with non-dimming luminaires.
The VITM4-SELVMOD converter provides a cost effective SELV switch input for overcoming the requirements of the IEE
17 th edition wiring regulations.
6 pole interface
connector and lead
supplied with
detectors
VITM4-S
Vitesse modular starter for non-dimming systems
VITM4-E
Vitesse modular extender for non-dimming systems
VITM4-SELVMOD
Pluggable SELV
switching module
Channel for channel nuts (zebs)
Removable gland plate with
3 x Ø20mm knockouts
3 x Ø20mm knockouts for rear
cable entry
4 x key slots to accept M6 (1/4”)
fixings
BESA box fixings
202mm
150mm
14
6m
m
12
7m
m
122mm
75mm
Fixing points
M6 (1/4”)
Warning. This device works at mains voltage. Be sure to take care when working with electricity.
 The box should be fixed on a smooth, flat surface or using drop rod fixings attached to channel nuts.
 Ensure that there is easy access to the wiring compartment and all connectors once the box is in-situ.
Height - allow 150mm for total height of unit (including connectors and cable)
Overview
Vitesse Modular 4 - Switching Modules
Product Guide
System Components
Installation
VITM4