CP Electronics VITM4-EBMHS-PRM - Manual

Overview
The EBMHS series of miniature PIR (passive infrared)
presence detectors provide automatic control of lighting
loads with optional manual control.
Three models are available: premium, direct dim, and
analogue dim all of which will switch incandescent,
fluorescent and compact fluorescent lighting. The direct
dim variant controls DALI or DSI digital dimming ballasts
whilst the analogue dim variant controls 1-10V dimming
ballasts.
The unit detects movement using a PIR sensor and turns
the load on. When an area is no longer occupied the load
will switch off after an adjustable time out period.
These units come complete with clips allowing unobtrusive
flush mounting into ceiling tiles or solid ceilings.
All functionality is fully programmable using an IR handset.
Features
Miniature HS PIR Presence Detector (standalone)
EBMHS
Product Guide
Standard power supply
PIR Sensor
Detects movement within the unit’s detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
The LED flashes Red to indicate the following:
RJ11 connector
The sensor head has a flying lead with a RJ11 plug at the
end plugs into the RJ11 socket on the power supply.
Power supply
This power supply has a 6A relay. It also has connections
for an external switch that can be used to turn on the load
when absence detection mode has been set or raised /
lowered with dimming variants.
Walk Test LED active when movement is detected
Valid setting received
Dimming version shown
Sensor head
PIR lens
which covers...
IR Receiver
Light Level Sensor
Status LED