CRU DE50 SAS/SATA 6G - Manual

Protecting Your
Digital Assets
™
Protecting Your
Digital Assets
™
CRU Data Express ® 50
SAS/SATA 6G Removable Enclosure
Thank you for purchasing CRU’s Data Express 50 SAS/SATA 6G Removable
Enclosure. The Data Express 50 is a reliable and versatile enclosure
constructed of solid steel and plastic. This product is created specifically for
2.5” SAS and SATA drives and is designed to fit into any 3.5” floppy or 5.25”
peripheral bay. The receiving frame offers 6 Gbps performance when used
with a SATA Revision 3.0 drive and host configuration. It is also compatible
with older SATA drive and host configurations.
Features
• Removable carrier allows quick and easy access to drives for hot
swapping or data mobility
• The mechanical keylock on the frame turns the unit on and locks
the carrier into place, preventing accidental ejection
• Receiving frame interconnect rated for 25,000 insertions
• Transfer data up to 6 Gbps using a SATA Revision 3.0 drive and
host configuration
DataExpress Branding
© 2013 CRU Acquisition Group LLC, ALL RIGHTS RESERVED. Data Express TM and CRU TM are trademarks of CRU Acquisition
Group, LLC and are protected by trademark law.
Product Warranty
CRU warrants this product to be free of significant defects in material and workmanship for a period of three years from the
original date of purchase. CRU’s warranty is nontransferable and is limited to the original purchaser.
Limitation of Liability
The warranties set forth in this agreement replace all other warranties. CRU expressly disclaims all other warranties, including
but not limited to, the implied warranties of merchantability and fitness for a particular purpose and non-infringement of third-
party rights with respect to the documentation and hardware. No CRU dealer, agent, or employee is authorized to make any
modification, extension, or addition to this warranty. In no event will CRU or its suppliers be liable for any costs of procurement
of substitute products or services, lost profits, loss of information or data, computer malfunction, or any other special, indirect,
consequential, or incidental damages arising in any way out of the sale of, use of, or inability to use any CRU product or service,
even if CRU has been advised of the possibility of such damages. In no case shall CRU’s liability exceed the actual money paid
for the products at issue. CRU reserves the right to make modifications and additions to this product without notice or taking
on additional liability.
FCC Compliance Statement: “This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.”
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a home or commercial environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
In the event that you experience Radio Frequency Interference, you should take the following steps to resolve the problem:
1)
Ensure that the case of your attached drive is grounded.
2) Use a data cable with RFI reducing ferrites on each end.
3) Use a power supply with an RFI reducing ferrite approximately 5 inches from the DC plug.
4) Reorient or relocate the receiving antenna.
Product Models Data Express 50 SAS/SATA 6G Removeable Enclosure
Host Interfaces SATA: up to 6 Gbps
Drive Types Supported • 2.5” SATA Hard Drives (up to SATA Revision 3.0)
• 2.5” SAS Hard Drives (up to SAS Revision 2.0)
Data Connectors One(1) SATA Revision 3.0/SAS connector
Operating System
Requirements • Windows 8.1, 8, 7, and Vista
• Windows Server 2012, 2008, and 2003 product families
• Mac OS X 10.4.x or higher
• Linux distributions that support SATA
Torque 2.5-inch hard drives, M3 screws: 4 inch-pounds max.
Compliance EMI Standard: FCC Part 15 Class B, CE
EMC Standard: EN55022, EN55024
Shipping Weight 1.83 pounds (includes accessories)
Product Dimensions 5.75in x 4.00in” x 1.00in” (146mm x 102mm x 26mm)
Technical Support Your investment in CRU products is backed up by our free technical
support for the lifetime of the product. Contact us through our website,
cru-inc.com/support or call us at 1-800-260-9800 or +1-360-816-1800.
A7-050-0007-1 Rev. 1.1
FOR HOME OR OFFICE USE