CRU RTX Secure 410-NJ - Manual

RTX ™ Secure SJ, NJ, and SV Quick Start Guide
1. RTX Secure Host Connections
This table shows connection types available in the RTX Secure models covered by this user
documentation. Other versions of RTX Secure are available from our distributors and at www.
cru-dataport.com.
2. Installation Steps
2.1 Hard Drive Installation
a. Pull the ejection handle on the TrayFree bay to open the bay door.
b. Insert a SATA hard drive into each bay. Make sure it is label-side up with the SATA
connection on the drive inserted first.
c. Close the bay door.
RTX and TrayFree are trademarks of CRU Acquisitions Group, LLC. Other marks are the property of their respective owners. © 2008, 2010 CRU Acquisitions Group, LLC.
Product Warranty
CRU-DataPort (CRU) warrants this product to be free of significant defects in material and workmanship for a period of two bnn years from the original date of purchase. CRU’s warranty is nontrans-
ferable and is limited to the original purchaser.
Limitation of Liability
The warranties set forth in this agreement replace all other warranties. CRU expressly disclaims all other warranties, including but not limited to, the implied warranties of merchantability and fitness for a par-
ticular purpose and non-infringement of third-party rights with respect to the documentation and hardware. No CRU dealer, agent or employee is authorized to make any modification, extension, or addition to this
warranty. In no event will CRU or its suppliers be liable for any costs of procurement of substitute products or services, lost profits, loss of information or data, computer malfunction, or any other special, indirect,
consequential, or incidental damages arising in any way out of the sale of, use of, or inability to use any CRU product or service, even if CRU has been advised of the possibility of such damages. In no case shall
CRU’s liability exceed the actual money paid for the products at issue. CRU reserves the right to make modifications and additions to this product without notice or taking on additional liability.
FCC Compliance Statement: “This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.”
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at this own expense.
In the event that you experience Radio Frequency Interference, you should take the following steps to resolve the problem:
1. Ensure that the case of your attached drive is grounded.
2. Use a data cable with RFI reducing ferrites on each end.
3. Use a power supply with an RFI reducing ferrite approximately 5 inches from the DC plug.
4. Reorient or relocate the receiving antenna
A7-468-0004-1 Rev. 1
Product Models RTX Secure 410-SJ, RTX Secure 410-NJ, RTX Secure 410-SV, RTX Secure 610-SV, RTX Secure 610-NJ,
RTX Secure 810-SJ, RTX Secure 810-SV
Host Interfaces • RTX Secure “SJ” models: eSATA
• RTX Secure “SV” models: single port-multiplied eSATA
• RTX Secure “NJ” models: SFF-8470 multi-lane SAS/SATA 3Gb/s
Drive Types Supported 3.5-inch SATA (Serial-ATA) hard disk drives
TrayFree Technology Yes
TrayFree Shock Absorbing Bays Yes (4-bay and 6-bay variants only)
Operating System
Requirements • Windows XP, Vista, Windows 7
• Mac OS X 10.2.6 or later
• Linux distributions using Kernel version 2.4 or above
Operating Temperature 50 – 85° Fahrenheit (10 – 30° Celsius)
Operating Humidity 5% to 95%, non-condensing
Power Switch 2 position: On / Off
Power Supply • Input: 100-240VAC
• Output: 220 Watts (4-bay models), 350 Watts (6-bay and 8-bay models)
Cooling Fan 8cm Ball Bearing Fan (two fans for 6-bay and 8-bay models)
Compliance EMI Standard: FCC Part 15 Class A, CE
EMC Standard: EN55022, EN55024
FIPS: FIPS 140-2, FIPS PUB 197
External Case Material Aluminum alloy
Shipping Weights • RTX Secure 4-bay Models: 23 pounds without drives, 29 pounds with drives
• RTX Secure 6-bay Models: 25 pounds without drives, 34 pounds with drives
• RTX Secure 8-bay Models: 28 pounds without drives, 40 pounds with drives
Dimensions 6.97” x 10.63” x 14.57” (177mm x 270mm x 370mm)
Technical Support We don’t expect anything to go wrong with your CRU product. But if it does, Tech Support is standing by
and ready to help. Contact us at http://www.cru-dataport.com/support. We also offer phone support at
(800) 260-9800.
Visit http://www.wiebetech.com/techsupport.php to download a copy of the complete User Manual.
Additional product information can also be found at www.cru-dataport.com and www.wiebetech.com.
RTX
TM
FOR OFFICE OR COMMERCIAL USE
Models Covered:
RTX Secure 410-SJ
RTX Secure 410-NJ
RTX Secure 410-SV
RTX Secure 610-NJ
RTX Secure 610-SV
RTX Secure 810-NJ
RTX Secure 810-SV
Connection SJ Model SV Model NJ Model
eSATA 4 (4 bays)
Port-Multiplied eSATA
1 (4 bays)
2 (6 & 8 bays)
Multi-Lane SAS/SATA 3Gbps (SFF-8470)
1 (4 bays)
2 (6 & 8 bays)