Dan Dugan Sound Design E - Manual (Page 9)

Dugan Model E User Guide
9
Chapter 2: Quickstart
This section provides step-by-step instructions to help you get started quickly. It includes
information to connect and install the Model E, make initial settings, and link units.
Step 1 Connections
Connect the provided power supply to the Model E.
Set the NORM-SLAVE switch on the rear panel to NORM (up) for normal (not linked)
operation.
The Model E can be interfaced with:
• an analog mixing board;
• a digital mixing board using analog or digital connections;
Analog
The Model E is a line-level device normally patched into the insert jacks (send and re-
turn) for each mic input channel on the board. Check the insert jack wiring on your mix-
ing board. If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS
insert cables to connect the Model E. Other configurations require special cables. The
Model E is wired as follows: tip = input, ring = output.
Figure 2-1 Analog connection