DekTec DTM-3200 IP-ASI Converter - Manual (Page 29)

DTM-3200 – OEM Ethernet TSoIP Converter
User Manual
29
4.4.8 ASI input settings
The ASI input settings are available only if the DTM-3200 is configured as ASI-to-IP converter.
Manageable Items - Category 0x83 – ASI input settings
Nr Variable Description Access Type
0x01 Packet size 0 = Generate IP packets with 188-byte
transport packets
1 = Generate IP packets with 204-byte
transport packets
2 = Use size of incoming packets
R/W (V) int8
0x02 Physical port Physical port number of ASI input;
always 1 for the DTM-3200
RO int8
0x03 Status 0 = Valid ASI signal is received
1 = No carrier detected
2 = Failed to lock to ASI input
3 = Input rate is below minimum
supported rate
RO int8
0x04 TS rate Transport stream rate (in bps@188) of
the received ASI stream
RO int32
0x05 Valid count Number of received bytes RO int64
0x06 Violation count Number of ASI code violation detected RO int64
0x07 Input select 0 = Autoselect (default)
1 = Select SPI input
2 = Select ASI input
R/W int8
This category requires an index to be sent with each command.
4.4.9 ASI output settings
The ASI output settings are available only if the DTM-3200 is configured as IP-to-ASI converter.
Manageable Items - Category 0x84 – ASI output settings
Nr
(hex)
Variable Description Access Type
1 ASI packet size 0 = Generate 188-byte packets
1 = Generate 204-byte packets
2 = Use size of received packets
R/W (V) int8
2 Physical port Physical port number of ASI output;
always 1 for the DTM-3200
RO int8
3 TS rate TS rate (in bps@188) of the generated
ASI stream
RO int32
This category requires an index to be sent with each command.