Future Automation LSM-S-BE - Manual (Page 9)

In
st
all
at
io
n
: S
ta
ge
4
Page 8 of 20 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM S BE - Lift System Medium Swivel Box Enclosure
Mounting the Base Panel
After the mechanism is in the correct position the next step is to lower the BASE PANEL
into place and fix from the underside through the BASE PANEL BRACKETS. A good tip
is to place the BASE PANEL in place and draw marks from the underside through the
BASE PANEL BRACKETS, then fix using a wood screw and a large penny washer, this
will allow you to adjust the position.
BASE
PANEL
BASE PANEL BRACKETS
You can adjust
the OUT position
by loosening
these screws and
sliding the switch
plate up or down