Future Automation PD - Manual (Page 16)

Tr
o
u
b
le
S
h
o
o
ti
n
g
:
Page 15 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PD1 & 2 - Projector Drop Mechanism
PD1 & 2 Projector Drop Mechanism - Trouble shooting guide
Having problems? - Check the following:
1. Are all the connections correct?
2. Is the mechanism being operated correctly?
If the mechanism does not operate correctly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. If this is the case, disconnect the
mains power immediately and contact your installer
Symptom Cause Remedy Page
Emergency stop removed Replace emergency stop 14
Remote control or batteries
faulty
Replace batteries or remote 15
Motor end stops incorrectly
set
Adjust end stop 10
Incorrect pin configuration
Terminate 8-pin RJ45 to 568/b pin
configuration
13
Faulty wiring Replace connector or cable 13
Faulty control box Test contact closure on control box 13
Incorrect settings Refer to instructions 14
Incorrect pin configuration
Terminate 6-pin RJ11 to
configuration supplied
14
ASC11 protocol error Amend Protocol 14
Lift not level Cables over lapping/damaged re-seat cables 11
Lift not working
Contact closure not working
RS232 not working