Holland Electronics ST-4000 - Manual (Page 7)

2 Selecting CATV or VHF/UHF Channels
The meter can be switched between CATV channels and VHF/UHF channels. To determine
how the meter is currently configured or to make a change, do the following:
From any menu screen Press CLR then Press 2, and then Press ENT.
Check to see whether the displayed channel is CH002 (CATV) or CH02 (VHF/UHF).
To switch back and forth between CATV and VHF/UHF channels, perform the following steps:
i. Press the On/Off key to turn the meter off
ii. Press and hold the SCAN key while pressing the On/Off key
iii. The meter has turned back on and switched from either CATV to
VHF/UHF or from VHF/UHF to CATV channels. Repeating steps i and ii
will switch the selected channels again.
3 Configuring Channel Line Up
The meter is factory programmed to read CATV channels 2-136 and VHF/UHF channels 2-69.
Customized CATV and VHF/UHF channel plans within these ranges can also be saved in the
“User Plan” mode.
In order to select or edit the “User Plan” channels, the meter must first be set to the proper
channel format (CATV or VHF/UHF). If you are unsure which channel format is currently
selected or want to change the selection, refer to Section 2.
3.1 CHANNEL PLAN
Select the factory programmed channel plans “NTSC CATV” or the custom “User Plan”
Press the 0/2
nd F key and then the SET key.
Press “” or “” to point “
” to “Channel Plan”. Press ENT key.
Use “” or “” to select the desired plan. Press ENT key.
LCD will display:
NTSC Channel Plan – CATV or VHF/UHF
User defined Channel Plan
3.2 CHANNEL EDIT
Specific channels can be included or removed from the “User Plan”.
Press the 0/2
nd F key then the SET key.
Press “” or “” to point “
” to “Channel Edit”. Press ENT key.
Use “” or “” to select the desired channel. Pressing SET will toggle the display between
ON (including the channel in the plan) and OFF (eliminating the channel from the plan).
Press “” or “” to move to the next channel. Press ENT key.
Repeat the process with the SET key to toggle the channel ON/OFF setting
LCD will display:
Select CH02 (ON) or don’t select (OFF)
Press key “SET” to edit
5
NTSC CATV
User PLAN
CH02 ON
Press “SET” Edit