ILUMINARC Ilumiline™ Inground Tri-12 IP - Manual (Page 13)

Installation
Ilumiline Inground IP Optic 25 Series User Manual Rev. 10 9
Ilumiline
Inground IP
products must be
linked using DMX cable in
a daisy chain (serial)
fashion. To comply with
the EIA-485 standard, no
more than 32 products
should be connected on
one daisy chain without
using a DMX optically-
isolated splitter. Doing
otherwise may result in
deterioration of the digital
DMX signal.
DMX Linking
You may link both Ilumiline Inground IP products to a DMX controller using a standard DMX
serial connection. If using other DMX products compatible with the Ilumiline Inground IP
product, you can control each individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX cables
needed to link the Ilumiline Inground IP products to a DMX controller, you may download the
“DMX Primer” document from the ILUMINARC® website at
www.iluminarc.com .
DMX Modes
The Ilumiline Inground Tri-12 IP Optic 25 RGB has five (5) different personalities. The
Ilumiline Inground 12 IP Optic 25 WW has only one (1).
Both products use a standard DMX data connection.
Refer to the Introduction chapter for a brief description of these modes. To configure
either one of the Ilumiline Inground IP products to work in these modes, refer to
the
Operation chapter. In addition, the DMX Values section provides detailed
information on these DMX modes.
Refer to the tables below for the highest DMX starting address recommended for each
mode.
Ilumiline Inground Tri-12 IP Optic 25 RGB
DMX Mode DMX Address DMX Mode DMX Address
ARC FULL 506 SOLID 512
ARC1 510 SPECIAL1 507
ARC1+D 509
Ilumiline Inground 12 IP Optic 25 WW
DMX Mode DMX Address
SOLID 512