Junger Audio C8611 - Dolby® E encoder - Manual (Page 7)

digital audio
modular
processing system
C8000
Dolby
®
E encoder
C8611
7/13
BACKUP
Pressing <BACKUP> will move all settings including the Presets to the
PC, so you can store the backup data to a file.
RESTORE Pressing <RESTORE> after loading a backup file will move all settings
including the Presets back to the module.
SETUP / ROUTING :
setup of the module and the Bus routing
From C8000 Bus
The audio busses from the C8k frame must be assigned to the encoder
for the respective signals. The labels at the encoder input show which
signals the encoder expects due to its configuration determined by
Program Config (see DOLBY E page). If some of the 8 input signals are
multiplexed in 8ch mode, you must check the respective channel check
boxes (see example above). This is the so called MixMux mode where
the module may be fed from a combination of 2Ch and 8Ch signals.
8ch Mux here one must select the bus that is fed in 8 channel Mux mode from an
upstream module. The check boxes below determine which channel pair
will be taken from the 8 channel Mux.