Junger Audio Transmission processor Level Magic LT - Manual (Page 10)

Operation manual Level Magic LT, chapter 2 – Functional description
1
1
1
The analogue audio inputs are RFI filtered. The analog outputs are
balanced and floating. All the audio connectors are mounted at the rear
panel. Standard XLR connectors are used wired to the AES standard:
pin 1
X Screen
pin 2 L + Audio (Live audio 0°)
pin 3 R - Audio (Return audio 180°)
Balanced connections are preferred whenever the other equipment
provides balanced inputs/outputs. All line level connections should be
wired with twin screened cable for low noise and reliability. The screen
for the input of the cable should be connected only at the signal source
end. The screen for the output cable should be connected only at he
Level Magic
TM LT connector.
An unbalanced source should still be connected to the Level Magic
TM
LT using twin screened cable. At the signal source end add a wire
jumper so that the screen is connected to the wire that will go to PIN3
of the XLR on the other end, where it connects to the XLÖR on the
Level Magic
TM LT.
If the equipment following the Level Magic
TM
LT only has unbalanced
inputs, then we recommend still to use a twin screened cable where
Pin1 and Pin3 are connected in the cable end at the following
equipment (that I s, not at the Level Magic
TM LT end).
The Level Magic
TM LT Digital Audio Level Processor can be remote-
controlled by means of parallel GPI contacts.
Use :
Remote Controlled changeover of presets and special
settings
Connector:
D-SUB 9pin, female
3.6
AUDIO
CONNECTIONS
3.7.1
GPI REMOTE
CONTROL
(PARALLEL
REMOTE)