KBC Networks MPEG-4 Decoder User Manual
Quick start guide, Dec-a-w, Decoder
Introduction
Welcome to KBC Networks’ Quick Start Guide for
the IP Decoder. This document provides some
quick tips on how to get up and running. For
more detailed information see the Downloads
section below.
Features:
MPEG4 compression encoding
NTSC/PAL support
RS-485/422, 232 support
Bi-directional audio
2, DI/DO bi-directional contact closures
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
Specification Sheets:
Release Notes:
IP Utility:
http://www.kbcnetworks.com/specification-
downloads/software
System Contents
Qty Description
1
Decoder
1
12Vdc PSU
Equipment Required for Physical
Deployment
Video only applications:
Ethernet Cat5 cable
Coaxial cable
Video and PTZ applications:
Ethernet Cat5 cable
Coaxial cable
Shielded &/or twisted pair wire for RS Data
wiring (see diagram)
Contact Closure Applications:
All above as required by application
Relay to supply the following voltages:
Contact Closure Specification
DI
Connection Design
TTL-compatible
logic
levels
Voltage
Trigger
(low)
Logic level 0: 0V ~
0.4V
Normal
(high)
Logic level 1: 3.1V ~
30V
Current
10mA ~ 100mA
DO
Connection Design
TTL-compatible
logic
levels
Voltage
Trigger
(high)
Logic level 0: 2.4V ~
5V
Normal
(low)
Logic level 1: 0.1V ~
0.6V
Current
50mA
Audio applications:
All above as required by application
Amplified audio source with stereo cable
and 3.5mm jack
Configuring the DEC-A-W*
Refer to provided documentation for pre-set
configuration settings. The following procedures
may be necessary if purchased from distribution
stock or in order to set custom configurations.
1. Connect an Ethernet crossover cable from
the LAN/WAN port of the decoder to either a
laptop or a PC LAN port.
2. Verifiy that the static IP address on the
laptop is set to 192.168.1.x subnet.
3. Open a web browser to access the Host on its
192.168.1.101 IP address; this is the default
address for the unit.
4. Enter the following to access the GUI:
ID: admin Password: admin
Note:
Ensure that all other network interface
connections including your laptop Wifi &
Windows Firewall are disabled.
5. Select: ‘Set Up’ to exit from the video
display and access the product menu.
If the IP address must be changed: Select:
<WAN Setting> make appropriate
configuration changes.
Select: <Apply>
Select: <Save>
Quick Start Guide
DEC-A-W*
Decoder
QSG_Decoder_MPEG4-Rev1206A
Copyright © KBC Networks Ltd. 2012