KBC Networks FPCD1-M4T-R-M1A User Manual
Page 6
Manual-FPCB1-Rev1012.pdf
Page 6 of 11
Copyright © KBC Networks Ltd.
1.4 Instruction of Disassembly
Instruction of Disassembly of KBC Product
(For EU Directive 2002/95/EEC━WEEE)
Tools Required:
1) 5 mm flat tip screwdriver
2)
Φ3 cross tip screwdriver
3)
Φ5 cross tip screwdriver
4) Size small snip nose pliers
5) 15 mm spanner
Steps for Disassembly:
1) Remove tightening screws of box cover (1 or 4-8 screws in general);
2) Remove lock nut for BNC with spanner;
3) Remove cover plate;
4) Remove tightening screws for printed circuit board (PCB);
5) In case the assembly has more than one PCB then continue removing the remain
tightening screws until none left;
6) Use snip nose pliers to loose the nut of flange and then remove optic cable
connector (jump wire);
7) Snip off power conducting cable and remove power switch /jack/etc.;
8) Take out all PCBs;
9) Disassembly of product completed.
Notice：When a product reaches the end of it
’s life—return to KBC