KLING & FREITAG K&F Line 212-9 - Manual (Page 17)

User's Manual LINE 212-6 / LINE 212-9
KLING & FREITAG GMBH ©2003 - 2005 Version 5.0, 23.03.2006 Seite 17 von 37
8.2 Arrayed Speaker Systems (Cluster)
If the loudspeakers are operated through the optional K&F C2 System Controller, we
recommend to turn on the ‘Top Low Cut’ switch for clustered operation. Thus the fre-
quency response for this application can be optimised (see also K&F C2 User's Manual).
If the Line 212 Systems are operated in a cluster without the C2 Controller (speakers are
set up directly next to one another), then lower the
'EQ LOW CUT' frequency as de-
scribed below!
EQ LOW CUT
Frequency 120Hz
Quality (Q) 0.55
Bandwidth (oct.) 2.35
Level -2.95dB
1.
If several Line 212-6 with a horn coverage pattern of 65°h x 50°v are arranged on
one side (cluster / array), it is recommended for the Line 212-6 to have a horizontal
array angle of 38.5° to one another (see fig. 2).
2. In a cluster comprised of a combination of the Line 212-6 with Line 212-9, we
recommend an array angle of 45° (see fig. 3).
3. With a rotated horn (Line 212-6 standing: 50°h x 65°v / Line 212-9 standing: 50°h
x 90°v), an array angle of 30° is recommended for both versions (see fig. 1).
Because increased interference effects occur when several 90° systems are arranged
next to one another, the clustering of several Line 212-9 is only conditionally recom-
mendable.
Fig. Fig. Fig. Fig. 1 1 1 1
30,0°
LLLLiiiine 212 ne 212 ne 212 ne 212---- 6 6 6 6
(horn rotated)
horn 50° h x 65° v
Line 212 Line 212 Line 212 Line 212----9 9 9 9
(horn rotated)
horn 50° h x 65° v
Fig. Fig. Fig. Fig. 2 2 2 2
38,5°
8,5°
Line 212 Line 212 Line 212 Line 212----6 6 6 6
(horn not rotated)
horn 65° h x 50° v
Fig. Fig. Fig. Fig. 3 3 3 3
45,0°
15,0°
Combination
(horns not rotated):
Line 212
Line 212 Line 212 Line 212----6 6 6 6
Horn 65°h x 50°v
with
Line 212
Line 212 Line 212 Line 212----9 9 9 9
horn 90°h x 50°v