Neotech Communications FSW-41HP - Manual (Page 2)

FSW-41HP
Unmanaged Industrial 4-port 10/100Base-TX + 1-port 100Base-FX SFP Ethernet Switch with PoE+
2 V1
Installation
1. Connect one end of the Ethernet cables to their corresponding ports on the product. Connect the
other end to the network equipment such as IP cameras, Switches or PCs. Insert the SFP and
connect the optical fiber cables to its connectors.
2. Connect the product with the power adapter and switch on the product, the PWR indicator should
then be ON. If it is not, please check whether the power cable is connected properly and the power
supply functions normally.
3. After all cables are connected, corresponding indicators will be on. Please refer to the Operational
Instructions for detail descriptions.
Cable Connections
Signal Type Cable Type Connector
Ethernet Cat. 5 or above RJ45
Optical SM/MM Optical fiber cable (depends on SFP) LC
Power supply Power cable 2-pin Terminal Block
Interface
Ethernet Port:
RJ45 Pin Assignment:
Pin Assignment
1 Output Transmit Data +
2 Output Transmit Data -
3 Input Receive Data +
4 Positive (VCC+)
5 Positive (VCC+)
6 Input Receive Data -
7 Negative (VCC-)
8 Negative (VCC-)
Power Connector:
Pin
Description
- +
Power Input GND
+48V
(DC)