NEXCOM ICES 254 - Manual (Page 75)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 61 ICEK 254-T2 Starter Kit User Manual
Chapter 3: System Setup
There is a metal plate supporting the mainboard that can be lifted up or
lowered down. The instructions below illustrate the step-by-step procedures.
NOTE: Before lifting up or lowering down, make sure the two spring-nuts
located on the left and right side of the metal support plate are inserted/
closed to the end-position as depicted in the diagram below.
Left spring-nut Right spring-nut
1. Hold on the left and right spring-nuts using both hands, and pull out
the spring-nuts to lift up or lower down.
2. After lifting up the mainboard, make sure the two spring-nuts are
inserted and closed to the end-position before plugging
any connectors and I/O cards, then power on the system.
3. After lowering down the mainboard, make sure the two spring-nuts
are inserted and closed to the end position before powering off the
system and closing the cover.