NEXCOM NEX 883 - Manual (Page 49)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 38
Chapter 3: Uefi Setup Utility
NEX 883 User Manual
3.4 Hardware Health Event Monitoring
Screen
In this section, it allows you to monitor the status of the hardware on your
system, including the parameters of the CPU temperature, motherboard
temperature, CPU fan speed, chassis fan speed, and the critical voltage.
CPU_FAN1 & 2 Setting
This allows you to set CPU fan 1 & 2’s speed. Configuration options:
[Full On] and [Automatic Mode]. The default value is [Full On].
CHA_FAN1 Setting
This allows you to set chassis fan 1’s speed. Configuration options:
[Full On] and [Automatic Mode]. The default value is [Full On].
Over Temperature Protection
Use this to enable or disable Over Temperature Protection. The default
value is [Enabled].
Case Open Feature
This allows you to enable or disable case open detection feature.
The default is value [Disabled].
Clear Status
This option appears only when the case open has been detected. Use this
option to keep or clear the record of previous chassis intrusion status.
Exit Advanced H/W Monitor Boot Security Main
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F7: Discard Changes
F9: Load UEFI Defaults
F10: Save & Exit
F12: Print Screen
ESC: Exit
Quiet Fan Function Control Hardware Health Event Monitoring
CPU Temperature
M/B Temperature
CPU_FAN1 Speed
CPU_FAN2 Speed
CHA_FAN1 Speed
Vcore
+3.30V
+5.00V
+12.00V
CPU_FAN1 & Setting
CHA_FAN1 Setting
Over Temperature Protection
Case Open Feature
: 42 O C
: 36 O C
: 4440 RPM
: N/A
: N/A
: +1.128V
: +3.360V
: +5.064V
: +12.249V
[Full on]
[Full on]
[Enabled]
[Disabled]