NEXCOM PEAK 876VL2 - Manual (Page 52)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 39
Chapter 3: BIOS Setup
PEAK 876VL2/877VL2 User Manual
Security
Change Supervisor Password
This field is used to set or change the supervisor password.
To set a new password:
1. Select the Change Supervisor Password field then press <Enter>.
2. Type your password in the dialog box then press <Enter>. You are lim-
ited to eight letters/numbers.
3. Press <Enter> to confirm the new password.
4. When the Password Installed dialog box appears, select OK.
To change the password, repeat the same steps above.
To clear the password, select Change Supervisor Password then press <En-
ter>. The Password Uninstalled dialog box will appear.
If you forgot the password, you can clear the password by erasing the
CMOS RTC (Real Time Clock) RAM using the RTC Clear jumper. Refer to
chapter 2 for more information.
Change User Password
This field is used to set or change the user password.
To set a new password:
1. Select the Change User Password field then press <Enter>.
2. Type your password in the dialog box then press <Enter>. You are lim-
ited to eight letters/numbers.
3. Press <Enter> to confirm the new password.
4. When the Password Installed dialog box appears, select OK.
Install or Change the
password.
BIOS SETUP UTILITY
Exit Chipset
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Main Advanced PCIPnP
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Passwordmig
Change User Password
Boot Security