One Systems U Bracket - Manual (Page 5)

5
108IM/208CIM
1. Remove the two plastic plugs from the position shown below, one plug from the top of the enclosure
and the second plug from the bottom of the enclosure.
NOTE: The U-Bracket MUST be mounted to the rigging points shown below. DO NOT USE THE OTHER M8
LOCATIONS FOR MOUNTING THE U-BRACKET!
2. Place the rubber washers over the top and bottom “U” bracket mounting holes
3. Mount the 108IM-U U-Bracket to the wall or ceiling surface. Insure that the bracket is properly and
securely mounted. The mounting surface MUST be capable of supporting the necessary weight to
achieve a safe working load. This must be done by a professional rigger or structural engineer familiar
with all local and national codes.
WARNING: Do not hang or otherwise suspend any other objects from the loudspeaker and “U” bracket
assembly!
4. Position the 108IM or 208CIM between the U-Bracket ends. Install the two M8 bolts, flat washers and
lock washers, one set on each side. This operation should be performed by at least two people. Once
the enclosure is safely mounted, adjust to the desired angle and tighten the M8 bolts.
5. A secondary safety cable (not supplied) is always recommended.
108CIM
1. Remove the two plastic plugs from the position shown below, one plug from the top of the enclosure
and the second plug from the bottom of the enclosure.
NOTE: The U-Bracket MUST be mounted to the rigging points shown below. DO NOT USE THE OTHER M8
LOCATIONS FOR MOUNTING THE U-BRACKET!