Et1111p series, Functional description, Assembly, startup, and dismantling – OT Systems ET1111P series User Manual

Page 2: Wall mounting installation

Advertising
background image

ET1111P Series

Industrial 10/100BASE-TX to 100BASE-FX Ethernet Media Converter with PoE/PSE

V3

2

The Port Status LEDs, Wall Mounting Kits, Optional DIN-Rail Kits

LED

State

Indication

PWR

Steady

Power on.

Off

Power off.

Power over Ethernet (PoE)

PoE

Steady

Power Device (PD) is connected.

Flashing Power Device is under detection stage

Off

Power Device (PD) is disconnected.

10/100Base-TX, 100Base-FX

Link/ACT

Steady

A valid network connection established.

Flashing

Transmitting or receiving data.

ACT stands for ACTIVITY.

Off

Ethernet connection is not established

SPD

Steady

100

Mbps

network

equipment

is

connected

Off

10

Mbps

network

equipment

is

connected or Ethernet connection is not
established


Functional Description

Meets EN55022: 2006+A1: 2007 EMC standard.

Supports IEEE802.3af Power over Ethernet (PoE) Power Sourcing Equipment (PSE).

Supports IEEE802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, Full/Half-duplex, Auto-Negotiation, Auto MDI/MDIX.

100Base-FX: Multi/Single mode SC type; WDM 100Base-FX: Multi/Single mode SC type.

Supports 1024 MAC addresses. Provides 128K bits buffer memory.

Power Supply: 48VDC Terminal Block power input.

Operating voltage and

M

ax. current consumption: 0.44A @ 48VDC or -0.44A @ -48VDC. Power consumption: 21.12W

Max.

-10°C to 60°C (14°F to 140°F) operating temperature range

Supports Wall Mounting installation.

Assembly, Startup, and Dismantling

Wall Mounting installation

Assembly: Securely fasten the wall-mount kits to the bottom of module by using the provided screws (4 pcs)

Mount the standalone unit onto a fixture, e.g. a plank, (either on the wall or on a flat surface) with at least 2 screws piercing
through the holes on the mounting frame to secure it in position.

Startup: Connect the supply voltage to start up the Media Converter via the terminal block (or DC JACK).

Dismantling: Locate and remove the securing screws. Usually, but not limited to, at least 2 screws.

Manual Earth Green manual is available on our website

www.ot-systems.com

Advertising