Oxmoor RMX-44 - Manual (Page 6)

Page 4
RMX-62 CALLOUTS
(Callouts refer to Figures 2.1, 2.2 and 2.3)
1. POWER LED - The front panel LED is illuminated
when the unit is on. The absence of an On/Off
switch is a performance safety feature, eliminating
accidental shutdown during operation.
2. INPUT CONNECTORS - XLR inputs, Pin 2 positive,
accept balanced or unbalanced signals from line-
level devices.
3. INPUT STAGE - The RF-suppressed input circuit is
electronically balanced (differential), and capable
of handling a maximum signal level of +24 dBu.
Balanced input impedance is approximately 80k
ohms, with a nominal input level range of -10 to
+8 dBu.
4. INPUT GAIN TRIM POTS - (labelled "INPUT 1,"
"INPUT 2,” etc.) Accessed through the front panel
with a small flat-blade screwdriver, these trim
pots adjust the input stage gain +/-15 dB, to
compensate for varying input signal levels.
5. OUTPUT STAGE - The output stage is electronically
balanced (push-pull) and AC coupled. Output
impedance is approximately 150 ohms. Each
output can provide a maximum level of +24 dBm
into a 600 ohm load, or +26 dBu unterminated.
6. BALANCED/UNBALANCED JUMPER BLOCKS -
These permit each output to be unbalanced
independently, if necessary (see SET-UP).
Figure 2.1: Front and Rear Panel Views of RMX-62
OXMOOR RMX-62 MIXING MATRIX
POWER
INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 INPUT 6
PIN 2 POSITIVE ON ALL
AUDIO CONNECTIONS
CONTROL PORT
FUSE POWER
CHASSIS
SERIAL NUMBER
OUTPUT B OUTPUT A INPUT 6 INPUT 5 INPUT 4 INPUT 3 INPUT 2 INPUT 1
1 4
9
10 11 8 2 7
7. OUTPUT CONNECTORS - XLR outputs, pin 2
positive, accommodate balanced or unbalanced
lines.
8. CONTROL PORT CONNECTOR - Female, 25 pin,
standard D-sub connector. Provides contacts for
jumpers or external switching needed to assign
routing of inputs to outputs. Latching contact
closures required (see SET-UP). Additional
contacts provide system mute capability and +15
VDC, 50 mA, output for powering LED's, etc.
9. CHASSIS GROUND POST - Nuts on a threaded stud
conveniently enable the installer to secure a
ground wire to the chassis.
10. POWER CONNECTOR - Standard IEC 3-pin
connector for AC power cord. Use only with
grounded (3-wire) outlets. Cord sets are available
for all world connection standards.
11. FUSE HOLDER - Replace only with approved
type of fuse in a rating appropriate to the mains
voltage, as indicated on back panel (see
SPECIFICATIONS).