Pengo Dirt Aggressor Auger - Manual (Page 2)

STEP ONE STEP ONE
Remove Dirt Components
Remove the Pengo ® TriFlow ® Pilot Bit & 40/50 Teeth as shown by
removing 1/2" Nuts & Bolts with 3/4" wrench or socket.
STEP TWO STEP TWO
STEP THREE STEP THREE
REPLACING TEETH REPLACING TEETH
Install Rock Head
Install Wear Caps
Auger head without
pilot & teeth.
1/2" Bolt
Tighten Nut onto
Bolt with 3/4"
wrenches
Insert Cast Rock Head into Auger Head and secure into place with
1/2" Nut & Bolt through center of auger as shown below. Make
sure rock head is orientated so that the holes in the rock head line
up with the holes in the Auger head.
Place Wear Caps onto Dirt/Rock Head as shown below. Make sure
that the holes in the wear caps line up with the holes in the auger
and rock head. Place 1/2" x 1-1/4" Hex Bolts into wear caps so
that the hex head seats in the hex recesses of caps. Tighten 1/2"
nuts onto bolts placed on underside of rock head with 3/4"
thin-walled socket.
NOTE: BoRH™ head comes with the P-21 RR tooth installed. To
replace teeth remove the worn teeth by using the Pengo
® Drift
Punch tool to pop teeth out of holders. Insert the P-21 RR tooth
into the cylindrical holders of the cast head and secure by using the
Pengo
® SH-85 soft hammer.
Description Part No.
6-BORH Auger Kit 137991
9-BORH Auger Kit 137992
12-BORH Auger Kit 137993
15-BORH Auger Kit 137994
18-BORH Auger Kit 137995
24-BORH Auger Kit 137996
P21-RR Carbide tooth 137990
1225 Drift Punch 137750
SH85 Soft Hammer 137737