Presentation Switchers PS100 - Manual (Page 5)

Page 5 PS100 Users Guide
Basics
Selecting a New Source Device to Display Selecting a New Source Device to Display
To display a new source, press the Source Selector bu on on the Front of the PS100 repeatedly
un l the LED on the Ac ve Source Indicator corresponds to the desired Source Port Selec on.
That image should now be visible on the Display Output and can be heard on the Stereo Audio
Output connectors.
Note: Selec ng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display Selecting a New Source Device to Display
(Using IR Remote) (Using IR Remote)
From the IR Remote controller, shown below, select the Right or Le bu ons un l the desired
Source is selected. If the front panel is viewable, you will see the Ac ve Source Indicator change
when each bu on is pressed.