Presentation Switchers PS110 - Manual (Page 2)

Page 2 Presentation Switchers, Inc.
Auto-Sense, Auto-Switching Auto-Sense, Auto-Switching
In many situaƟ ons a control system is oŌ en unnecessary, complicated, costly, and confusing.
When a new device is connected to the PS110 system, it is immediately switched to the display.
This feature is especially useful in board room and collaboraƟ ve presentaƟ on systems.
Selecting a New Source Device to Display Selecting a New Source Device to Display
To display a new source, press the Source Selector buƩ on on the Front of the PS110 repeatedly
unƟ l the LED on the AcƟ ve Source Indicator corresponds to the desired Source Port SelecƟ on.
The image should now be visible on the Display Output and can be heard on the Stereo Audio
Output connectors.
Note: SelecƟ ng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display Selecting a New Source Device to Display
(Using IR Remote) (Using IR Remote)
From the IR Remote controller, shown below, select the Right or LeŌ buƩ ons unƟ l the desired
Source is selected. If the front panel is viewable, you will see the AcƟ ve Source Indicator change
when each buƩ on is pressed.