Saturn ST-EK8408 - Manual (Page 2)

2 3
GB
Dear Buyer!
We congratulate you on having
bought the device under trade
name «Saturn». We are sure
that our devices will become
faithful and reliable assistance in
your housekeeping.
Important Safeguards
When using electrical appliance, the
following basic safety precautions
should always be followed:
1. Read all instructions.
2. Before use checks that the
voltage power corresponds to
the one shown on the
appliance nameplate.
3. Unplug from outlet when not
in use and before cleaning.
Allow too cool before cleaning
the appliance.
4. Do not let cord hang over
edge of that table or counter,
or touch hot surface.
5. Place the appliance on the
flat surface. Do not place on
the heated surface.
6. To protect against electric
shock, do not immerse cord,
plug, power base and kettle
in water or other liquid.
7. Close supervision is
necessary when any
appliance is used by or near
children.
8. Do not touch hot surface. Use
handle or knobs only.
9. Do not operate any appliance
with a damaged cord or plug
or after the appliance
malfunctions. Return the
appliance to the nearest
authorized service center for
examination, repair or
adjustment.
10. If the supply cord is
damaged, it must be replaced
by the manufacturer or its
service agent or a similarly
qualified person in order to
avoid a hazard.
11. Do not use outdoors.
12. Do not use the appliance for
other than intended use.
13. The kettle can only use with
the stand provided.
14. If the kettle is overfilled,
boiling water may be ejected.
15. This appliance is not intended
for use by persons (including
children) with reduced
physical, sensory or mental
capabilities, or lack of
experience and knowledge,
unless they have been given
supervision or instruction
concerning use of the
appliance by a person
responsible for their safety. It
is not advised to use this
appliance by children under
14.
16. Children should be supervised
to ensure that they do not
play with the appliance.
17. Save these instructions.
Operation
It is recommended that operate the
kettle several times following the
below instruction and discard off the
water before first use. This will
remove the material or dust remained
in the appliance which is caused by
the manufacturing process.
1. Open the lid by pulling the
Lid upwards and fill water
into the kettle. Then replace
the lid otherwise the kettle
could not be cut off power
automatically after water
being boiled. Alternatively the
water can be filled through
the spout.
2. Caution: the filled water
level must be between the
Max and Min level as
indicated on the housing. Too
less water will do damage to
the heat element and if the
water is overfilled, boiling
water may be ejected.
3. Replace the kettle on the
Power Base and connect to
power supply. Position the
kettle so that the spout of
kettle is facing away from
you.
4. Press down the switch to “1”
position and the lamp will be
illuminated. And water begins
to be heated up. Do not
remove the lid while the
water is boiling.
5. Power will be cut off
automatically and switch will
be back to “0” position once
water has been boiled. And
the lamp will be off.
6. The boiling process can be
terminated at any time by
lifting the kettle off the Power
Base.
Caution:
– Never operate the appliance empty.
In the event of this case occurred, the
thermal cut-off inside the kettle would
operate to cut off power automatically.