Saturn ST-EK8405 - Manual (Page 2)

2
3
GB
Dear Buyer!
We congratulate you on having
bought the device under trade
name «Saturn». We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Important safeguards
1. When using electrical appliance,
the following basic safety
precautions should always be
followed:
2. Read all instructions.
3. Before use checks that the
voltage power corresponds to
the one shown on the appliance
nameplate.
4. Unplug from outlet when not in
use and before cleaning. Allow
too cool before cleaning the
appliance.
5. Do not let cord hang over edge
of that table or counter, or
touch hot surface.
6. Place the appliance on the flat
surface. Do not place on the
heated surface.
7. To protect against electric
shock, do not immerse cord,
plug, power base and kettle in
water or other liquid.
8. Close supervision is necessary
when any appliance is used by
or near children.
9. Do not touch hot surface. Use
handle or knobs only.
10. Do not operate any appliance
with a damaged cord or plug or
after the appliance
malfunctions. Return the
appliance to the nearest
authorized service center for
examination, repair or
adjustment.
11. If the supply cord is damaged,
it must be replaced by the
manufacturer or its service
agent or a similarly qualified
person in order to avoid a
hazard.
12. Do not use outdoors.
13. Do not use the appliance for
other than intended use.
14. The kettle can only use with
the stand provided.
15. If the kettle is overfilled,
boiling water may be ejected.
16. This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning use of
the appliance by a person
responsible for their safety. It
is not advised to use this
appliance by children under 14.
17. Children should be supervised
to ensure that they do not play
with the appliance.
18. Save these instructions.
Operation
1. It is recommended that operate
the kettle several times
following the below instruction
and discard off the water
before first use.
This will remove the material or
dust remained in the appliance
which is caused by the
manufacturing process.
2. Open the lid by pulling the Lid
upwards and fill water into the
kettle. Then replace the lid
otherwise the kettle could not
be cut off power automatically
after water being boiled.
Alternatively the water can be
filled through the spout.
3. Caution: the filled water level
must be between the Max and
Min level as indicated on the
housing. Too less water will do
damage to the heat element
and if the water is overfilled,
boiling water may be ejected.
4. Replace the kettle on the Power
Base and connect to power
supply. Position the kettle so
that the spout of kettle is
facing away from you.
5. Press down the switch to “1”
position and the lamp will be
illuminated. And water begins
to be heated up. Do not
remove the lid while the water
is boiling.
6. Power will be cut off
automatically and switch will be
back to “0” position once water
has been boiled. And the lamp
will be off.
7. The boiling process can be
terminated at any time by
lifting the kettle off the Power
Base.
Caution:
 Never operate the appliance
empty. In the event of this
case occurred, the thermal
cut-off inside the kettle would