Saturn ST-EK8008 Dewberries - Manual (Page 3)

4
surface, away from hot objects (e.g.
hotplates), naked flames; do not place
under curtains or low wall-cupboards.
11. You should never leave the appliance
unattended during use.
12. This appliance is not intended for use
by person (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance. It
is not advised for children under 14 to use
this appliance.
13. Use the kettle only with the base unit
supplied, and do not use the base unit for
any other purposes.
14. Never remove the kettle from its base
unit while in operation. Switch the
appliance off first.
15. Take care to close the lid properly
before switching on. Otherwise, the
appliance will not switch off automatically
and hot water may overflow.
16. The kettle is for heating water only
and is not to be used for any other liquids.
BEFORE USING FOR THE FIRST TIME
1. Remove all packing materials from
the kettle.
2. Before connecting of the kettle
check that voltage, indicated on the
rating label, corresponds to the mains
voltage in your home.
3. Fill the kettle with cool water up to
the “MAX” mark and boil it. Empty the
kettle. The appliance is ready for use.
INSTRUCTION FOR USE
FILTER PLACING
1. Open the lid by pressing on the lid
release button.
2. Place the filter between the two
grooves near the spout at the front of
the kettle.
3. Ensure that the filter is pressed
down to the bottom of the grooves and
fits correctly then close the lid.
NOTE: Never leave the filter loose in
the kettle. Never remove the filter while
the kettle contains hot water.
FILLING
1. Remove the kettle from the base
unit.
2. You can fill the kettle with water via
the spout or by opening the lid, by
pressing on the lid release button.
3. Not recommend to fill with less
than 1liter of water to prevent the
kettle running fry while operating.
4. Do not fill with more than 1.5 liters
5
of water (up to “MAX” mark). Avoid
overfilling to prevent the water spilling
out during the boiling process.
SWITCHING ON
1. After filling your kettle with water,
place the kettle on the base unit.
2. Connect plug to power supply and
pull down the On/Off switch. The
appliance will begin to operate and the
indicator light will come on.
SWITCHING OFF
When the water boils, the kettle will
switch off automatically and the
indicator light will go off.
NOTE: This appliance has a safety
system, which automatically switches
off the heater element if the appliance
is inadvertently switched when empty,
or if it boils dry. In this case, let the
appliance cool down completely, before
filling with water again.
SWITCHING ON AGAIN
The kettle can be switched on again
after cooling down about 15-20
seconds, while the kettle has been
switched off automatically.
CARE AND CLEANING
1. Always remove the plug from the
power supply and let the appliance cool
down completely.
2. Clean the outside of the kettle and
the base unit with a soft damp cloth.
then wipe with a dry cloth. Do not use
scouring
3. Descale at regular intervals. Use a
descaling agent, which can be obtained
from specialist shops and follow the
instructions given.
FILTER CLEANING
1. Remove the filter out of the kettle.
2. Place under a tap and rub gently
any remaining by soft brush (do not
included).
3. Replace the filter between the two
grooves near the spout at the front of
the kettle.
STORAGE
The cord could be winded into the base
unit that has a cord storage
compartment.
Technical Data:
Input Power: 2000 W
Rated Voltage: 220-230 V
Rated Frequency: 50 Hz
Rated Current: 9 A
Capacity: 1.7 l