Saturn ST-HT7265 - Manual (Page 2)

2 3
GB
CONVECTION HEATER
Dear Buyer!
We congratulate you on
having bought the device
under trade name «Saturn».
We are sure that our devices
will become safe and reliable
assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing
temperature to a warm room)
may cause condensation
inside the unit and a
malfunction when it is
switched on. In this case
leave the unit at room
temperature for at least 1.5
hours before switching it on.
If the unit has been in
transit, leave it indoors for at
least 1.5 hours before
starting operation.
Before operating this unit, please
read these instructions carefully
Usage Guidance
· Please read this guidance
carefully before using the
electrical appliance, so that
you can use it correctly.
· Please keep this guidance
well.
Brief Introduction of the
product:
The convector adopts convecting
heating technology, and has a
high heating efficiency,
centralized heat and adjustable
heating range.
The convector has a reasonable
foot structure not easy to be
toppled by accident.
Assemble before you use:
Please assemble the feet and the
body in the order given on the
picture below:
1. Place the convector on the flat
desk or carton.
2. Insert 4 position pins of the
feet into the position holes of the
body.
3. Tight the fixed screw to
connect body and feet.
Usage:
4. Please check before you use:
A: The heating wire and electric
wire cannot be broken.
B: Please do not use the socket
lower than 10A for fear of any
accident.
5. Use the convector on the flat
place to avoid being toppled.
6. There are 2 switches for the
power setting. I - for 800W, II -
for 1200W. You can get 3 power
setting 800W, 1200W, 2000W
(800W+1200W).
4. There is a thermostat knob for
adjusting heating. You can rotate
the knob to get your desired
heating level.
5. If you stop using convector,
turn off all the power switch, and
then, put off the plug.
6. If you want to move the
convector, please turn off the
switches, then, put off the plug,
and hand on the handle on the
back of the convector.
Components:
Electric Drawing: