Toyotomi FB-38N(FS) - Manual (Page 23)

4
SECTION B:
UNPACKING
UNPACKING
1. Unpack the unit carefully.
2. Check to see if there are any loose screws that may have occurred in transit.
3. Take accessories and the Operation and Maintenance instructions out of the carton.
STANDARD INSTALLATION PARTS
The following standard installation parts are enclosed with unit.
1. Exhaust Pipe Top (1 pc.)
2. Rubber Fuel Hose (1 pc.)
3. Hose Band (2 pcs.)
4. Remote Control (1 set)
5. Remote Control Cord (3 m)
6. Adhesive Tape (2 pcs.)
7. Wooden Screw (2 pcs.)
SECTION C:
INSTALLATION
WARNING: This unit must be installed in accordance with these instructions, local codes,
ordinance and/or in the absence of local codes, the latest edition of the national
fire protection association code.
WARNING: Check and comply with local codes that may apply to Water Heater(s) before
beginning the installation.
WARNING: This unit should be installed by a licensed, authorized person(s) due to the
necessity of making electrical, water and fuel connections.
SELECTING A LOCATION
Select a place to install the Water Heater where water pipes, electric supply, and surrounding
surfaces will be at safe and noise prevention distances.
1. Select a place which is free of moisture, water spills, pools or snow.
2. Select a place which draining can be done easily.
3. Select a place which the Fuel Tank can be installed safely.
4. Select a place which is free of combustible substances.
5. The surrounding walls should be finished with non-flammable materials (concrete block,
mortar, or plaster are allowable).
6. The floor on which the Water Heater is installed must prevent intensive vibrations or shock
and must be strong enough to bear the weight of the water heater.